Yellow Lime looks almost yellow at first. Give it a second, and the green starts to come through. TeckWrap balances both sides with a satin chrome surface that keeps the shine soft.

Key Attributes

• Two-sided color: Yellow leads in direct sun, while lime green becomes clearer from an angle or under softer light.
• Brushed metallic glow: Fine metallic pigment gives the surface a smooth sheen without the glare of mirror chrome.
• Clean adhesive system: Henkel solvent acrylic adhesive holds securely, stays weatherproof, and removes without leaving residue.
• Stable installation: The PET release liner keeps the film flat and helps installers manage tension across larger panels.
• Heat-conformable film: The material follows mirrors, edges, and moderate recessed areas with controlled heat.
• Paint-safe removal: The removable adhesive leaves the factory finish untouched when installed and removed correctly.

Park it in full sun and Yellow Lime leans toward fresh citrus yellow. Walk around the car and the green becomes harder to miss. The shift is gradual, so one panel may read more yellow while another looks greener. Shade brings out more lime. Direct light lifts the yellow again. The satin chrome surface changes what you notice too. Instead of a glossy flash, it shows a soft metallic grain across the body lines.

OEM Match

• Closest in brightness to Lamborghini Verde Mantis
• More yellow and less green than Porsche Acid Green

Like those factory colors but drive something else? Yellow Lime brings a similar yellow-green direction to a Supra, Corvette, Mustang, GT-R, or Model 3.

Film Construction

• Film Type: Premium polymeric hybrid vinyl film with air-release channels and Satin finish
• Film Thickness: 0.11 mm
• Release Liner: silicone-coated release liner
• Adhesive: Henkel solvent-based acrylic, ultra-weather-resistant, 12 um dry
• Roll Width: 5 ft (1.52 m)
• Full Roll Length: 59 ft (18 m)

Performance

• Service temperature: -30°C to +45°C
• Release force: 0.18 N/25mm (standard 0.10-0.30)
• Initial tack: 1015 g/25mm (standard 800-1500)
• Peel strength (180°): 8.1 N/25mm (standard >=4.9)
• Adhesion strength: 70 (standard >=60, no shifting)
• Aging tested: high and low temperature release without adhesive residue
• Storage shelf life: 2 years at +10°C to +20°C, 50% RH, dry conditions, away from sunlight

Warranty

• Built for long-term outdoor use, commonly up to 3 years on vertical panels and around 2 years across a full wrap depending on climate and maintenance.

• Application temperature: +17°C to +23°C
• Tools: squeegee with buffer, knife, masking tape, heat gun, magnets, gloves, IR thermometer
• Conformability: smooth and medium-curved surfaces
• Post-heat: 90-100°C
• Cure: 24 hrs above 10°C; 48 hrs at room temperature recommended
• Overlap: 3-4 mm
• Non-directional film.
• Clean, degrease, and dry the surface before installation.
• Remove the protective cap or PET protective layer before applying heat.
• Aftercare: use pH-neutral products and avoid hot wax or strong solvents.

TeckWrap statements, technical information, and recommendations are based on product testing believed to be reliable, but they do not guarantee identical results in every installation environment. The buyer should confirm suitability for the intended vehicle and use.

Screen images may vary from the physical film. Always check a real color swatch before ordering, and use rolls from the same production LOT for full-wrap color consistency.

Film performance depends on storage, surface preparation, installation method, climate, and maintenance. Scratches during installation or daily use, labor, transportation, and consequential damages are not covered by standard product warranty.