Most yellow wraps wash out to school-bus pale or cheap egg-yolk in overcast light. Citron Yellow (EV01) stays sharp, high‑beam bright, cool‑toned, and green‑leaning, even when the sun drops.

Key Attributes

High‑visibility bite: a clean, acidic yellow with a cool-green bias that reads neon without looking juvenile Gloss that cuts through: hybrid polymeric film with UV‑stable pigments resists fading and holds its electric snap season after season Smooth lay‑in: Henkel solvent acrylic adhesive lets you reposition, then locks down; peels clean with no residue Conformable edge wrap: glides over mirrors, bumper intakes, and door handles without lifting or silvering Paint‑safe release: premium PET liner keeps the film flat during install; factory clear coat stays untouched on removal Citron Yellow (EV01) lands somewhere between a highlighter and a ripe lemon rind. In direct sun it throws a white‑hot glare that grabs attention from three blocks away. In shade, it cools into a zesty lime‑tinged yellow, never muddy or dull. Stand it next to a typical aftermarket yellow-the difference is instant: this one has a sharp, acidic energy that doesn't beg for forgiveness. It's the color of a prototype test car, not a taxi.

OEM Match

Closest to Porsche Signal Yellow Same saturation as BMW Austin Yellow Brighter than Ferrari Giallo Modena Cooler than Corvette Acceleration Yellow Love those factory yellows on a Porsche or BMW? Now put that same voltage on your Supra, R8, GT500, or any coupe that wants to be seen before it's heard.

Film Construction

• Film Type: Premium polymeric hybrid vinyl film with air-release channels and Gloss finish
• Film Thickness: 0.11 mm
• Release Liner: silicone-coated release liner
• Adhesive: Henkel solvent-based acrylic, ultra-weather-resistant, 12 um dry
• Roll Width: 5 ft (1.52 m)
• Full Roll Length: 59 ft (18 m)

Performance

• Service temperature: -30°C to +45°C
• Release force: 0.18 N/25mm (standard 0.10-0.30)
• Initial tack: 1015 g/25mm (standard 800-1500)
• Peel strength (180°): 8.1 N/25mm (standard >=4.9)
• Adhesion strength: 70 (standard >=60, no shifting)
• Aging tested: high and low temperature release without adhesive residue
• Storage shelf life: 2 years at +10°C to +20°C, 50% RH, dry conditions, away from sunlight

Warranty

• Built for long-term outdoor use, commonly up to 3 years on vertical panels and around 2 years across a full wrap depending on climate and maintenance.

• Application temperature: +17°C to +23°C
• Tools: squeegee with buffer, knife, masking tape, heat gun, magnets, gloves, IR thermometer
• Conformability: smooth and medium-curved surfaces
• Post-heat: 90-100°C
• Cure: 24 hrs above 10°C; 48 hrs at room temperature recommended
• Overlap: 3-4 mm
• Non-directional film.
• Clean, degrease, and dry the surface before installation.
• Remove the protective cap or PET protective layer before applying heat.
• Aftercare: use pH-neutral products and avoid hot wax or strong solvents.

TeckWrap statements, technical information, and recommendations are based on product testing believed to be reliable, but they do not guarantee identical results in every installation environment. The buyer should confirm suitability for the intended vehicle and use.

Screen images may vary from the physical film. Always check a real color swatch before ordering, and use rolls from the same production LOT for full-wrap color consistency.

Film performance depends on storage, surface preparation, installation method, climate, and maintenance. Scratches during installation or daily use, labor, transportation, and consequential damages are not covered by standard product warranty.