Forget the ordinary. Step into the shadows with TeckWrap Velour Black (CPX301M) , the paint protection film that redefines your vehicle's presence. This isn't just a wrap; it's a statement of sophistication and a fortress for your factory paint, all rolled into one.

Key Attributes

• Color and protection together: TeckWrap Velour Black Matte Color PPF | changes the look while helping protect the original paint.
• TPU protection layer: helps defend against road debris, light scratches, and everyday contamination.
• Dry-install support: air-release liner helps installers position larger sections with consistency.
• Easy maintenance: the top coating helps with water, dirt, and stain management.

TeckWrap Velour Black Matte Color PPF | Car Paint Protection Film (CPX301M) is positioned to change the vehicle's character while keeping the original paint intact.

OEM Match

• Pairs well with factory black roofs, gloss-black trim, and performance styling packages.
• Use a physical swatch to compare gloss depth against piano black or OEM black paint.

Film Construction

• Film Type: Color PPF aliphatic TPU paint protection film
• Film Thickness: 180-220 um
• Release Liner: Air-release liner for dry installation
• Adhesive: Low-tack acrylic pressure-sensitive adhesive
• Roll Width: 5 ft (1.52 m)
• Full Roll Length: 59 ft (18 m)

Performance

• Service temperature: -40°C to +90°C
• Release force: 0.18 N/25mm (standard 0.10-0.30)
• Initial tack: 1015 g/25mm (standard 800-1500)
• Peel strength (180°): 8.1 N/25mm (standard >=4.9)
• Adhesion strength: 70 (standard >=60, no shifting)
• Aging tested: high and low temperature release without adhesive residue
• Storage shelf life: 2 years at +10°C to +20°C, 50% RH, dry conditions, away from sunlight

Warranty

• Up to 5 years depending on film line, climate, exposure, and maintenance.

• Application temperature: +18°C to +25°C
• Tools: squeegee with buffer, knife, masking tape, heat gun, magnets, gloves, IR thermometer
• Conformability: painted panels, bumpers, mirrors, and moderate curves
• Post-heat: 80-90°C where required
• Cure: 24-48 hrs after installation
• Overlap: 3-4 mm
• Non-directional film.
• Clean, degrease, and dry the surface before installation.
• Remove the protective cap or PET protective layer before applying heat.
• Aftercare: use pH-neutral products and avoid hot wax or strong solvents.

TeckWrap statements, technical information, and recommendations are based on product testing believed to be reliable, but they do not guarantee identical results in every installation environment. The buyer should confirm suitability for the intended vehicle and use.

Screen images may vary from the physical film. Always check a real color swatch before ordering, and use rolls from the same production LOT for full-wrap color consistency.

Film performance depends on storage, surface preparation, installation method, climate, and maintenance. Scratches during installation or daily use, labor, transportation, and consequential damages are not covered by standard product warranty.