TeckWrap Clear E75 Crystal is a gloss clear paint protection film built on aliphatic TPU (Lubrizol ESTANE®) with a hydrophilic top coat. Unlike standard hydrophobic Lotus Effect films, the hydrophilic coating spreads water into a thin even layer that sheets off cleanly, reducing water spotting and helping rinse away road grime under rain.

The self-healing surface reflows light scratches with heat. At 330 μm total thickness with a 180 μm application layer, E75 Crystal absorbs stone chips, scratches, splatter, and minor abrasions while enhancing factory paint clarity. In accelerated weathering tests equivalent to 9 years, ESTANE® TPU maintained appearance and physical performance.

For owners in wet climates, regions with hard water, and anyone who hates dealing with water spots after every rain. Backed by TeckWrap's decade of paint protection film manufacturing experience and worldwide installer network.

Film Construction

• Film Type: Clear Protective aliphatic TPU paint protection film
• Film Thickness: 180-220 um
• Release Liner: Air-release liner for dry installation
• Adhesive: Low-tack acrylic pressure-sensitive adhesive
• Roll Width: 5 ft (1.52 m)
• Full Roll Length: 59 ft (18 m)

Performance

• Service temperature: -40°C to +90°C
• Release force: 0.18 N/25mm (standard 0.10-0.30)
• Initial tack: 1015 g/25mm (standard 800-1500)
• Peel strength (180°): 8.1 N/25mm (standard >=4.9)
• Adhesion strength: 70 (standard >=60, no shifting)
• Aging tested: high and low temperature release without adhesive residue
• Storage shelf life: 2 years at +10°C to +20°C, 50% RH, dry conditions, away from sunlight

Warranty

• Up to 5 years depending on film line, climate, exposure, and maintenance.

• Application temperature: +18°C to +25°C
• Tools: squeegee with buffer, knife, masking tape, heat gun, magnets, gloves, IR thermometer
• Conformability: painted panels, bumpers, mirrors, and moderate curves
• Post-heat: 80-90°C where required
• Cure: 24-48 hrs after installation
• Overlap: 3-4 mm
• Non-directional film.
• Clean, degrease, and dry the surface before installation.
• Remove the protective cap or PET protective layer before applying heat.
• Aftercare: use pH-neutral products and avoid hot wax or strong solvents.

TeckWrap statements, technical information, and recommendations are based on product testing believed to be reliable, but they do not guarantee identical results in every installation environment. The buyer should confirm suitability for the intended vehicle and use.

Screen images may vary from the physical film. Always check a real color swatch before ordering, and use rolls from the same production LOT for full-wrap color consistency.

Film performance depends on storage, surface preparation, installation method, climate, and maintenance. Scratches during installation or daily use, labor, transportation, and consequential damages are not covered by standard product warranty.