Tired of wrestling with crooked decals or wasting time eyeballing measurements? Meet your new secret weapon: TeckWrap masking tape with pre-printed measurements-the tape that takes the guesswork out of car wrapping. No more "Oops" moments when you realize your vinyl stripe is off by an inch after halfway through

Key Attributes

• Color character: TeckWrap Masking Tape with Pre-Printed Measurements brings a Tools finish that updates the vehicle without permanent paintwork.
• Liquid surface effect: polymeric hybrid film construction supports a smooth, consistent finish.
• Trusted adhesive system: weather-resistant acrylic adhesive supports installation and clean removal.
• Installation support: air-release channels help align large panels and manage bubbles.
• Conforms under heat: suited for mirrors, bumpers, grilles, and moderate curves when installed correctly.

TeckWrap Masking Tape with Pre-Printed Measurements is positioned to change the vehicle's character while keeping the original paint intact.

OEM Match

• Use TeckWrap Masking Tape with Pre-Printed Measurements beside the factory paint under natural light to confirm the match.
• Use rolls from the same production LOT for consistent color across a full wrap.

Film Construction

• Film Type: Tools
• Film Thickness: product-specific
• Release Liner: product-specific
• Adhesive: product-specific
• Roll Width: product-specific
• Full Roll Length: product-specific

Performance

• Service temperature: product-specific
• Release force: 0.18 N/25mm (standard 0.10-0.30)
• Initial tack: 1015 g/25mm (standard 800-1500)
• Peel strength (180°): 8.1 N/25mm (standard >=4.9)
• Adhesion strength: 70 (standard >=60, no shifting)
• Aging tested: high and low temperature release without adhesive residue
• Storage shelf life: 2 years at +10°C to +20°C, 50% RH, dry conditions, away from sunlight

Warranty

• Warranty and use conditions depend on the specific item.

• Application temperature: product-specific
• Tools: squeegee with buffer, knife, masking tape, heat gun, magnets, gloves, IR thermometer
• Conformability: consult product use before application
• Post-heat: product-specific
• Cure: product-specific
• Overlap: 3-4 mm
• Non-directional film.
• Clean, degrease, and dry the surface before installation.
• Remove the protective cap or PET protective layer before applying heat.
• Aftercare: use pH-neutral products and avoid hot wax or strong solvents.

TeckWrap statements, technical information, and recommendations are based on product testing believed to be reliable, but they do not guarantee identical results in every installation environment. The buyer should confirm suitability for the intended vehicle and use.

Screen images may vary from the physical film. Always check a real color swatch before ordering, and use rolls from the same production LOT for full-wrap color consistency.

Film performance depends on storage, surface preparation, installation method, climate, and maintenance. Scratches during installation or daily use, labor, transportation, and consequential damages are not covered by standard product warranty.